E-Bodies.org Cuda Challenger Forum
- Welcome to E-Bodies.org Cuda Challenger Forum.
Recent posts
#1
Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) / Re: Caliper sealing washers
Last post by headejm - Today at 04:32:16 PMI bought this relatively inexpensive Dorman kit. Has not leaked in four or so years.
#2
Quote from: Skdmark on Today at 12:00:17 PMIt looks like crackedback has not been on the forum since Nov 2023.
Hope he's ok.
I spoke to him about 2 months ago and am pretty sure he is retired. I had to go elsewhere
#3
1
Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) / Re: Caliper sealing washers
Last post by 1970 cuda Joe - Today at 04:03:33 PMI'm thinking the aftermarket is too hard & not allowing it to crush....Thank you, Joe
#4
1
Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) / Re: Is this a partial VIN?
Last post by 1970 cuda Joe - Today at 04:00:45 PMQuote from: 6bblgt on Today at 03:12:13 PMa 1968 non-HP engine will not have a VIN stamping
Thank you. I'm beginning to see that....Joe
#5
Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) / Re: Is this a partial VIN?
Last post by 6bblgt - Today at 03:12:13 PMa 1968 non-HP engine will not have a VIN stamping
#6
I'm looking for an original rallye dash light bar lens. If anyone upgraded their lenses and happened to save the originals, please PM me. A little warped is ok, I'll make it work. 
#7
Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) / Re: Caliper sealing washers
Last post by Katfish - Today at 01:01:51 PMI had similar problem. Not all copper washers are equal.
Most of the aftermarket washers are thinner than factory.
I ended up buying some washers from local dealer, and that worked.
Mopar Action had an article on the issue.
Most of the aftermarket washers are thinner than factory.
I ended up buying some washers from local dealer, and that worked.
Mopar Action had an article on the issue.
#9
I wonder what the population is in this community?
#10
Engine, Transmission & Rear End / Re: Distributor Vacuum Advance...
Last post by Skdmark - Today at 12:06:59 PMThe distributor I got with my electronic conversion kit around 1990 came with an adjustable vacuum advance.
