Main Menu

Dakota Digital Sensor Cables

Started by slimpickins, May 14, 2021, 04:36:07 PM

Previous topic Next topic

0 Members and 1 Guest are viewing this topic.

slimpickins

Just received my RTX Gauges from DD and now I'm wondering how everyone has routed the Oil press and temp sensor cables through the firewall?  I have an American Autowire Classic Update wiring harness installed.

Also where have you mounted the control box? I have seen the box mounted in the dash and under the driver's kick panel just wondering what the consensus is for best location.

Thx

anlauto

I put mine on the back side of the dash figuring all the factory wire could reach it without extending them, but if you're rewiring the whole car, I guess it doesn't really matter :dunno:
I've taught you everything you know....but I haven't taught you everything I know....
Check out my web site ....  Alan Gallant Automotive Restoration

slimpickins

Thx for the reply! Looks like a pretty good location


JonH

Mounted mine on the brake/clutch pedal bracket. Sensor wires through the speedo cable hole....

FSHTAIL

Did any of you get the GPS speedometer setup?
1973 BS23H Cuda' 340/TKX 5 speed (70 AAR clone-ish)

anlauto

Sorry, I'm just using the speed sensor that is already in the Tremec 5spd transmission. :dunno:
I've taught you everything you know....but I haven't taught you everything I know....
Check out my web site ....  Alan Gallant Automotive Restoration