Issue with Just Dashes dashpad

[cuda hunter]

@Cuda_mark   Did you find a solution to this problem? 

[Cuda_mark]

@Cuda_mark   Did you find a solution to this problem?

Well, I'm not sure I would call it a solution but I just followed their youtube video (link above) and advice. Poke a needle in the bubble and rolled it flat. It doesn't bubble up anymore but if you look really close, you can see a trace mark of where the bubble was. It got harder to notice once the windshield was in. It isn't so obvious that I would consider pulling the dash back out at this point.

My advice to others would be to put their dashes out in direct sunlight BEFORE they install them in the car. That way you could pin any bubbles that form before they leave a witness mark and/or send it back to just dashes if the adhesion is horrible.