NOS Mopar R3 340 Block

[SassyAAR]

NOS Mopar Performance R3 340 Race Block in original box and pallet.

Mopar P/N P4876795
Standard Deck 9.56 Nom with 8.9 Min
Rough bored @ 3.905 with a 4.080 max overbore possible
Non-Siamese
59 Degree Tappet Angle
340 Journals
2 Bolt drilled with provisions for 4 bolt

This is a late 1990s R3 High Nickel T/A "Resto" block I have been holding on to for awhile.
I have it on a pallet and can help coordinate freight shipping through SAIA etc. on my end.
Buyer pays shipping. I am in Monterey, CA.

$5000

[340Challman]

  I didn't see that, I didn't see that. Good luck with the sale.
I'm going to tell the wife to hide my computer now.

[HP2]

damn, that thing is sexy just sitting on a pallet.

[Matt13]

Jeezus! I'm in the East Bay. I could zip down there an drive back up with that bad boy. Now I just need 5 grand....

[EB3-GranCoupe]

Wow, I could use this, and the W-2 heads & manifold.....and i could use $6600 to buy it all.   

[Chryco Psycho]

Pretty much the ulimate small block casting , you can drill for 6 bolts / cylinder & use W8 or W9 heads & make 800 hp

[Shane Kelley]

I'm curious. What's the castings on the side say?

[SassyAAR]

Here are the numbers on it:

[Shane Kelley]

Thank you. Not that it matters I was just curious if they actually said 340 on them. Looks like that's a no.

[headejm]

@Shane Kelley You could add this to your 340 collection. 

[Shane Kelley]

@Shane Kelley You could add this to your 340 collection. 

I might have considered it if it said 340 on it!   

[TA/Z06/GSXR1100]

Is this the same as the (TA) casting ? If not , which is better?

[autoxcuda]

[quoteere author=TA/Z06/GSXR1100 link=topic=17737.msg230393#msg230393 date=1597430450]
Is this the same as the (TA) casting ? If not , which is better?
[/quote]

Not same

Yes stronger in all ways... also heavier

Don't know why max bore is 4.08. Was there another non-siamese with bigger bore range?

[gzig5]

I'm pretty sure I've read of these going 4.125  or a little less. I could be thinking of the Ritter block though.  But 4.08 is only a .040 over 340 so I would hope there is more meat in there than that.  I'd love to have one but I'm holding out for someone to do an aluminum smallblock.