A833 input shaft

[walt1800]

I am looking for an input shaft for an 833 trans. 23 spline 25 tooth. Input shaft retainer is part number C94796 which I believe is the small bearing.   

[Chryco Psycho]

they are specific to the matched countershaft , tooth count & pitch of the gear
I would start with Brewers or Passon

[71GranCoupe]

they are specific to the matched countershaft , tooth count & pitch of the gear
I would start with Brewers or Passon

I deal with Brewers and they will take the time to insure you are ordering the right stuff too.

[anlauto]

Another vote for Brewers...Wayne will have everything you need...I just got an internal reverse lever from them on Thursday...

[dodj]

I've dealt with Jamie Passon and would recommend giving him a call. He knows A833's.

[Chryco Psycho]

I have dealt with both , both are very knowledgable & great to deal with , no favorite between them

[HP_Cuda]

The input shaft retainer you speak of is 4.3"???not 4.8?

[fc7cuda]

 I've had this one around for a while and I am not sure what it's out of.  it's a 23 spline with 18 Gear teeth. would that make it from a three speed trans ?

Thanks

[walt1800]

Yes it's the smaller retainer....4.3 I believe the 4.8 was used on the 18 spline for some 440's and the Hemi. The 25 spline with a 25 tooth gear was not used on many trans, most on small blocks in 70.  The 24 tooth was used more from 71 on,

[HP_Cuda]

This is from a 4.3 retainer, I think this is what you are talking about.

[walt1800]

Yes that looks like the one if it is a 25 tooth gear

[HP_Cuda]

Let me do a count tomorrow and get back to ya.

[walt1800]

Sounds good, I will check back later for your reply. Thanks!

[walt1800]

HP_CUDA ....any luck with the tooth count?

[HP_Cuda]

It's a 23 spline.