Brake Linkage Pivot Bolt / Sleeve

[Dex]

G'afternoon everyone,

After hours of searching for my bolt, nut, and sleeve; I've decided to just make what I need until I can find mine or come across an extra someone may have. I've found detailed measurements on the bolt, and know what style nut was used. I haven't been able to find much info on the sleeve. I believe the OD is 0.500 (1/2), and the ID would be 0.375 (3/8), give or take. I don't know the length. Does anyone have access to the sleeve to help me with the measurements?

[Chryco Psycho]

Sorry I don't have access to the part you need to give you measurements but Welcome to the site 

[1 Wild R/T]

Basically the length is close to the same as the length of the tube welded to the pedal plus the thickness of the bushing flanges and add .050 for clearance... 

[JonH]

I have one. Appears it is from a 71-72. Different from the picture you have. The part you have circled is 2 pieces on mine. It has a sleeve inside where the bushings are. The bolt is 5/16". If you want measurements from this let me know.

[Dex]

Basically the length is close to the same as the length of the tube welded to the pedal plus the thickness of the bushing flanges and add .050 for clearance... 

I'll keep this in mind. Thank you for the reply!


@JonH I would love to have the measurements please!

[JonH]

Ok the overall length on the 1 I have is 3.065". Mine has a sleeve inside that measures .5 OD and .375 ID. Hope that helps. If you need more info or pics let me know...@Dex

[72RoadRunnerGTX]

Bolt? Are you sure you should be looking for a bolt and sleeve for that pivot assembly?

[1 Wild R/T]

Bolt? Are you sure you should be looking for a bolt and sleeve?

& Yes some were built like shown....

[Dex]

Thanks for the replies everyone!

I'll update the thread with a pic whenever I have time to make the pieces. I'll also do the same if my original shows up.