Main Menu

Is the brake booster pushrod adjustable? (70 Challenger)

Started by Dakota, November 14, 2020, 06:00:51 PM

Previous topic Next topic

0 Members and 1 Guest are viewing this topic.

Dakota

I have a little too much travel in my brake pedal before the brakes kick in.   The brakes work great once that point is reached.   I have the same booster as what's shown in this picture that Cody posted a while back. 


edison1970

Yes. It is adjustable.  Be careful not to go too far. The brakes will drag.  I have the same issue with mine.



anlauto

Quote from: edison1970 on November 14, 2020, 06:26:59 PM
Yes. It is adjustable.  Be careful not to go too far. The brakes will drag.  I have the same issue with mine.

Here's a question about this...do you think it's possible for the rear brakes to "drag" and not the front brakes if this rod is adjusted incorrectly ?

Keep in mind the reservoir for the front brakes is closer to the booster ...
I've taught you everything you know....but I haven't taught you everything I know....
Check out my web site ....  Alan Gallant Automotive Restoration

edison1970

I'm not sure about the answer to your question but I adjusted the rod out too far and about a quarter mile from my house, I  had to pull over and readjust it. I pushed in the clutch and the car came to a halt. Front brakes were smoking.

Chryco Psycho

The front brake reservoir is closer to the firewall so it is more likely that hte front brakes will drag , I can't see the rear brakes dragging without the front as the piston for the front brakes has to move to activate the rear brakes .

anlauto

Quote from: Chryco Psycho on November 14, 2020, 11:15:01 PM
The front brake reservoir is closer to the firewall so it is more likely that hte front brakes will drag , I can't see the rear brakes dragging without the front as the piston for the front brakes has to move to activate the rear brakes .

That's what I thought too, thank you. :drinkingbud:
I've taught you everything you know....but I haven't taught you everything I know....
Check out my web site ....  Alan Gallant Automotive Restoration


VCODE

Dakota, there is a tool made for getting the correct measurement. About .030 between push rod and piston clearance.
Bob

Burdar

Incorrectly adjusted rear brake shoes will cause a low pedal also.  The shoes should have a slight drag on the drum when they are adjusted correctly.

As for the booster pushrod...

I measured the distance from the master cylinder mounting flange to the bottom of the master cylinder piston.  Then I adjusted the pushrod to match this measurement.(from the tip of the pushrod to the booster mounting flange)  Once the gasket is installed between the two parts and "crushed" you'll have a little bit of clearance.  Right or wrong, that is how I did it.

Dakota

Thanks for all the replies. 

I made a rough adjustment this afternoon.  Much better!  Best I can tell, there's no drag. 

I will probably get one of the measuring tools to make sure it's correct.  Since I didn't want to disconnect the brake lines from the master cylinder, there's not a lot of room for my caliper. 

I was pleasantly surprised at how easy it was to adjust since the pushrod can be partially removed from the booster to get better positioning with the tools and the coiled brake lines provide a bit of "give" for moving the master cylinder.