Pre-bent SS brake lines.

[Rdchallenger]

Does anyone make them for E-bodies?

[Floyd]

I got mine from Fine Lines:

https://www.sstubes.com/

[MoparLeo]

Just an FYI.   S/S brake lines are difficult to seal at the fittings. Must be very tight...

[anlauto]

 

[Brads70]

  x 2    I found I had to tighten them , loosen, then tighten again a few times to stop it from leaking.

[JS29]

  Almost to the point of striping! 

[RUNCHARGER]

Hmm: I back them off and give them another shot but they always seem to seal without crazy force.

[jimynick]

Put a dab of never-seize between the flare nut and flare edge to allow the nut to tighten better due to lessened friction between them and use a good flare wrench, too. Mind your knuckles!