Stiffening plates

[61K T/A]

Did Chrysler install 1 or 2 plates for the spring hangers on the Hemi powered cars? I'm only aware that 1 plate was used between the hanger and support. Was there a second plate used in front of the support?

[anlauto]

There's two per side of car(4 altogether). One on the front side and one on the backside of the mounting area.

[Cuda Cody]

And Hemi cars also got a small metal square washer on the front lower control arm bump stop.

[61K T/A]

 

[cataclysm80]

And Hemi cars also got a small metal square washer on the front lower control arm bump stop.

Did all the 15 inch wheel cars get that?

I'd think that they'd be harder to find if it was only a Hemi thing.

[cataclysm80]

Hemi cars also had a pinion snubber reinforcement welded to the floor right?

[larry4406]

And Hemi cars also got a small metal square washer on the front lower control arm bump stop.

Cody - any pictures of the washers?

[anlauto]

And Hemi cars also got a small metal square washer on the front lower control arm bump stop.

I've found those on 383 cars...never could explain it 

[Cuda Cody]

Only guessing, but I would think it would be a 15" wheel thing?

And Hemi cars also got a small metal square washer on the front lower control arm bump stop.

Did all the 15 inch wheel cars get that?

I'd think that they'd be harder to find if it was only a Hemi thing.

[Cuda Cody]

I can not remember seeing a special plate?  But maybe?     I will take a look next time I'm under the body of one.

Hemi cars also had a pinion snubber reinforcement welded to the floor right?

[Cuda Cody]

@larry4406  here's a photo of them.

And Hemi cars also got a small metal square washer on the front lower control arm bump stop.

Cody - any pictures of the washers?

[61K T/A]

I can not remember seeing a special plate?  But maybe?     I will take a look next time I'm under the body of one.

Hemi cars also had a pinion snubber reinforcement welded to the floor right?

I found a pic of the plate. Just have to figure how to post it.

[Cuda Cody]

@61K T/A  in this link steps #5, #6 & #7 show you how easy it is to post photos.  You can click the steps to enlarge them too.

https://forum.e-bodies.org/forum-help-and-suggestions/14/how-to-post-on-the-forum/558/

I can not remember seeing a special plate?  But maybe?     I will take a look next time I'm under the body of one.

Hemi cars also had a pinion snubber reinforcement welded to the floor right?

I found a pic of the plate. Just have to figure how to post it.

[61K T/A]

I found this online. Never seen one of these before.

[61K T/A]

Ordered these today.
http://www.ebay.com/itm/70-71-Mopar-E-Body-Front-Rear-Spring-Hanger-Reinforcement-Plates-Hemi-6-Pack-/182531859464?hash=item2a7fbf2408:g:wKIAAOSwVm5Y8p4o&vxp=mtr