Main Menu

splash sheilds

Started by culp71, May 16, 2018, 06:39:54 AM

Previous topic Next topic

0 Members and 1 Guest are viewing this topic.

culp71

so 71 cuda, 4 frame K member splash shields?
small front set of splash shields rivet to the frame between the K frame arms,
but how about behind, I see holes in the frame and can find a "starter" splash shield, but
what about the pass side?

Cuda Cody

Is it an auto or manual?

culp71



anlauto

Only AUTOs had one starter shield on the driver's side, nothing on the passenger side except the two front ones as mentioned.
I've taught you everything you know....but I haven't taught you everything I know....
Check out my web site ....  Alan Gallant Automotive Restoration

culp71

thank you once again  :bigthumb:

Burdar

Did the splash shields still get attached with rivets in 71?  I was thinking that was 70 only.  When did they go to screws?

culp71

I believe the front two where riveted on and the rear was screwed.
but don't know for sure...


anlauto

I've seen both on 71's, I typically use screws on 71's 
I've taught you everything you know....but I haven't taught you everything I know....
Check out my web site ....  Alan Gallant Automotive Restoration

Jim AAR

The front Splash Shields on my 4 spd AAR were screwed on from the factory, they had never been taken off before I took them off to blast and paint the engine compartment.

My build Date was 3-70 so that may be why they were screwed and not riveted though.  :notsure: