Main Menu

Billboard installation on polished car?

Started by Shoooter, July 02, 2021, 09:30:40 PM

Previous topic Next topic

0 Members and 1 Guest are viewing this topic.

Shoooter

I'm in the process of polishing my Cuda . Once done I have to get the billboards installed. Should I skip polishing under where the billboard will go or do it then wipe if down with wax and grease remover?  I found a old picture of where the billboard roughly goes so I can polish close to the edges so it will be done up to the edge of the decal. I don't see a point in doing the whole quarter just to wipe all the wax off of it?? Any suggestions?

torredcuda

You will want to wipe it down with wax and grease remover so as long as the paint is fairly flat, no orange peel, no sense in polishing it.
Jeff   `72 Barracuda 340/4spd
https://www.facebook.com/jeffrey.hunt.750

Northeast Mighty Mopar Club
https://www.facebook.com/groups/1486087201685038/

Shoooter

 I wiped the whole car down before I started.  I might do the edge area of the billboard then read wipe