Challenger R/T hood emblem hole locations

[wanderlustin]

Forgive me if I missed a previous thread on the topic.  I have a new reproduction R/T hood and need to locate the holes for the D O D G E and 440 SIX PACK emblems.  Does anyone have a sketch on the most accurate method of locating the required holes?  Also need the proper drill size(s).

[Skdmark]

Here's a thread on the DODGE lettering location.
https://forum.e-bodies.org/body-shop/5/dodge-hood-lettershood-emblem-measurements/18586/msg239055#msg239055

[headejm]

@wanderlustin 1st question: Where have you been hiding?

There is another thread about the R/T hood badge location. This is the measurements on my 1970 Challenger.

[wanderlustin]

@Skdmark thank you!  Very helpful!

[wanderlustin]

@headejm thank you!  Good info.  I guess I've been wanderin too much and need to sit down and catch up on all the good info you've all been swapping!  Thanks again.