E body part?

[cudabin]

Hi,
  I am new to this forum and have recently purchased a 1974 Cuda project car that came with a mix of 1970-1974 Barracuda parts. In the mix was the following. Can anyone help identify this part. It is a piece of flat bar with oval cut holes with a flat seal attached. Cannot find any Chrysler markings or part numbers on it. Thank you.

Linkback: https://forum.e-bodies.org/cuda-and-challenger-general-discussion-roseville-moparts/2/e-body-part/26051/

[tparker]

It's hard to tell by the photo, but my guess is it goes on the inside of the hood. Sorry, I don't know what it called.

you can see it here.
https://www.moparmall.com/OE-Style-Molded-Hood-Insulation-Pad-for-1968-1969-p/827-035-_-825-336-x25.htm

[MoparCarGuy]

It is the Hood to Radiator Seal.

[71GranCoupe]

It is the Hood to Radiator Seal.

I agree. It should measure 51 1/4 +/-

[Jay Bee]

Okay, my hood to rad support seal has no "flat bar". As far as I know, no ebody has any flat metal that's part of that seal.

Welcome to the forum and where are you in Ontario. Close enough to Moparfest to attend? I'm in Niagara Region.

[anlauto]

It's off of a 1970 Dodge Charger. It screws to the front bumper assembly to seal off the area between the front of the hood and the front bumper 

[cudabin]

Thanks for noticing Jay Bee. Live in the Windsor area and have attended Moparfest in the past. Hoping to attend this year again.

[cudabin]

Thank you anlauto….much appreciated.