Main Menu

T/A washer tubing T

Started by muscleonly, February 27, 2022, 04:34:03 PM

Previous topic Next topic

0 Members and 1 Guest are viewing this topic.

muscleonly

Could someone tell me how the washer tubing T is suppost to mount to the underside of the fiberglass hood, mine has no holes

Floyd

Underside pic of an original hood.

Floyd

Close up (different original) of the location for the two small plastic straps that hold the hose. One strap broken off in this pic.


muscleonly

Would you drill 2 holes and push T in afraid I'd go through other side

Floyd

Yes, I would assume that raised section of underside against which the t-fitting and plastic loops are attached is hollow.  There appears to be about a half inch of space between the inner and outer layer of fiberglass on the original.  You'll need to careful when drilling, but there should be enough depth for the fasteners to catch.


JS29

Use a piece of brake line, cut it so the drill bit sticks out just enough to pierce the first layer.  :alan2cents: