Electronically actuating Shaker cold air door

[Skdmark]

Has anyone ever seen or converted a Shaker cold air door mechanism to be operated electronically instead of via cable?
How was it done?

I'm thinking of mounting a high torque servo motor to the bellcrank, wired to an under dash controller with an activation switch.

[anlauto]

Then you're still relying on one cable why not put an actuator inside the bubble ?

[Skdmark]

Then you're still relying on one cable why not put an actuator inside the bubble ?

I'm trying to eliminate the dash cable. I figured there is more room outside the Shaker than inside.This way I don't have to add the cable hole in the firewall. Adding and hiding a couple of wires is much easier.

If someone has succesfully mounted an actuator inside the shaker, I would be open to that too. Pontiac had a solenoid inside the 70 1/2 -72 Trans Ams shaker. The solenoid was actuated by the carb linkage and would open and close with the throttle.