No Turn signals

[Caparco]

new flashers new bulbs, brake lights work all four hazard lights work fine, just no turn signals

I had no power coming out of the column in the brown and green wire, after much reading of other posts I assumed it was the switch, purchased a beautiful NOS original switch off the internet
  Had the same results, sent it to Jim at JSResto he tested it for me and said the switch is working fine
  So now I'm here with a good switch new flashers new bulbs, why am I still not getting power to my green and brown wires coming out of the turn signal switch?
Is there another culprit I should look for?

[Chryco Psycho]

there are 2 different flashers  1 for hazard & 1 for turn
check for power at the flasher in & out , from there the power goes up the column to the TS switch

[Caparco]

Good job! Right again you are.
No power at the flasher, chased that down to the radio connector, they were both getting something minute like 0.06 V
So I just threw a jumper wire to the key on accessory giving the flasher power, works perfectly!

Thanks so much