Main Menu

tach testing

Started by GoMangoBoys, February 19, 2021, 10:59:46 AM

Previous topic Next topic

0 Members and 1 Guest are viewing this topic.

GoMangoBoys

I want to test my tach before it goes into the car.  I would hate to have to pull it out later.  Can someone tell me how to wire it up outside of the car.  I can connect it to a different engine if I know what each connection is.  I know I will need 12V, ground and the negative on the coil.  Not sure which terminals to connect these to.
Thanks

Skdmark

12v to the long stud
Tach wire to short stud
Housing to ground

Image is Cody's from another thread.
You are not entitled to your opinion. You are entitled to your informed opinion. No one is entitled to be ignorant.
-Harlan Ellison

(O OI====II====IO O)    (O O{]{]{] ][ [}[}[}O O)
:stayinlane:

greentween

At this stage, you may want to consider the RT Eng tach board. Especially If you want to add a CD ignition. With an MSD or Pertronix digital box you need that board for that tach to work. When you replace the board, you can tell which of the 2 posts are for the 12v and the coil via the instructions from RT Eng. His board also allows you to calibrate it.