426 Hemi motor mount boss not drilled

484HemiCuda · December 09, 2019, 06:08:59 PM

I have a Gen 2 426 Hemi from Mopar Performance that has been built. However the Hemi motor mount bosses have not been drilled. I need a fixture to locate the holes. Any suggestions on where to get a fixture to locate the holes?

Chryco Psycho · December 09, 2019, 06:33:56 PM

Welcome to the site from Panama

Unfortunatly I don't have a template for those holes

Flatdad · December 17, 2019, 05:13:55 AM

I measured this from an old Keith Black water block. The lower three holes are the crossbolt holes.

Hemi Motor mount recommendation? Started by b5cuda on Modern Hemi Swaps	8 Replies 1126 Views	Last post: August 31, 2022, 05:31:13 AM by Filthy Filbert
motor mount problem Started by Jonny on Cuda & Challenger General Discussion (ROSEVILLE MOPARTS)	6 Replies 1123 Views	Last post: August 01, 2018, 08:13:44 AM by Burdar
Is this a factory motor mount? Started by 70 Challenger Lover on Engine, Transmission & Rear End	3 Replies 617 Views	Last post: August 11, 2019, 08:31:28 AM by 70 Challenger Lover
Motor mount Identification Started by fc7cuda on General Topics	5 Replies 99 Views	Last post: Today at 07:57:54 PM by fc7cuda
Motor Mount Recommendation Started by kawahonda on Engine, Transmission & Rear End	45 Replies 3963 Views	Last post: December 03, 2018, 09:49:23 AM by HP_Cuda