Main Menu

clutch rod firewall boot

Started by dave73, September 13, 2018, 02:13:27 PM

Previous topic Next topic

0 Members and 2 Guests are viewing this topic.

dave73

Is the firewall boot for the clutch rod tight around the rod? Asking because mine isn't, probably worn and is letting in engine heat into the cabin. If a new one is tight, I'll be getting a new one.

anlauto

Yes..A nice tight seal....just like what every walrus wants !
I've taught you everything you know....but I haven't taught you everything I know....
Check out my web site ....  Alan Gallant Automotive Restoration

Timbbuc2

Quote from: anlauto on September 13, 2018, 02:41:55 PM
Yes..A nice tight seal....just like what every walrus wants !
I guess the walrus wants to give his seal of approval. :thankyou:
Get in, I'll drive


dave73

What's the simplest way to change out the boot? Undo the rod from the engine bay side or under the dash at the pedal?

Chryco Psycho

You need to pop the clip off , usually under hood is easier

anlauto

I've taught you everything you know....but I haven't taught you everything I know....
Check out my web site ....  Alan Gallant Automotive Restoration

RUNCHARGER

Interior, fairly easy job and well worth it.
Sheldon


1970A-66Challenger

Working through my auto to manual transmission conversion. Just confirming what is above since the boot looks like it can be installed from the engine bay as well facing inward. 

Is the clutch rod boot installed from the interior with the "boot" protruding into the engine bay?


anlauto

Quote from: 1970A-66Challenger on December 22, 2022, 03:41:39 AM


Is the clutch rod boot installed from the interior with the "boot" protruding into the engine bay?
YES
I've taught you everything you know....but I haven't taught you everything I know....
Check out my web site ....  Alan Gallant Automotive Restoration