Hemi Heat Tubes - how to block off/remove

[ZEN357]

I would just caps them off and remove the tubes.

[Topcat]

I would just caps them off and remove the tubes.

https://www.ebay.com/itm/66-71-426-Hemi-Intake-and-Exhaust-Manifold-Heat-Tube-Block-Off-Plate-Set/401499955535?hash=item5d7b43214f:g:qWQAAOSw~gRVwoo5&vxp=mtr

[Mopsquad]

I would just caps them off and remove the tubes.

Yes, that's my plan now.

https://www.hooverautoparts.com/products/Exhaust/M%201012.php

[RUNCHARGER]

Yes: Getting the shaker to clear everything and fit right is the worst part of converting to EFI IMO.

[Mopsquad]

Yes: Getting the shaker to clear everything and fit right is the worst part of converting to EFI IMO.

Nice! And you went Fitech.  That'll save a few steps.  I'm doing the multiport Holley EFI.  So far the clearance is good.  I'm still in the intake and linkage phase. Fuel and computer is next.

Chiiliwack?

Great Canadian band.  Need to play some "Fly at Night" 

[RUNCHARGER]

Ha, ha: Yes I remember them in the 70's. Your multiport will work a lot better. I took photos of the shaker baseplate I butchered to get this one under the hood but I am too embarrassed to post it. It was tough getting around the fuel lines and keeping everything low.

[Chryco Psycho]

The Multiport is awesome , cannot wait to see the pix once you get it installed 

[Brads70]

The cap on the manifold might be a good/easy spot to weld  the O2 sensor bung? 

[Mopsquad]

The cap on the manifold might be a good/easy spot to weld  the O2 sensor bung? 

I thought about that too.  If I can get at it and also if the location is optimal for the computer to read the signal.