**SOLD** New Strange Driveshaft

[7dcuda]

New, never installed driveshaft from Strange Engineering. 3" Chrome Moly tubing with Spicer weld ends. Heavy duty Spicer 1350 U-Joints. Spicer heavy duty MOPAR 30 spline trans. yoke. 43 3/8" measured from center to center of U- joint caps. High speed balanced. Would currently cost @ $500 from Strange. Asking $275 shipped anywhere in the lower 48. Good deal for someone that has a project that could use the 43 3/8" length.

[70_440-6Cuda]

Do you know the application?  Big / small block, Auto / 4 Spd, 8-3/4 / Dana?  Thanks

Not sure of the length, but I am running a 440 Auto with Dana and need a driveshaft - I currently have the 8-3/4 rear so I know the length is differen

[7dcuda]

Sorry, but no I don't.  You'd just have to measure to see if the 43 3/8" length would work for your installation. I have another one that's 49 3/4" center to center but it currently has a GM trans. yoke on it...but that could obviously be changed.  

[7dcuda]

SOLD