72-4 Challenger tail light assembly studs

[blown motor]

Where can I get the studs that hold the tail light assembly in place. Need three of them.

[Burdar]

The cheapest solution would be to buy a small section of threaded rod and cut it to length.

R/T Specialties MIGHT list them.  You'd end up spending more on shipping then you would for the parts though.

[Brads70]

If your not concerned about " correct" maybe a trip to brafasco, fastenal, bolts plus to get the appropriate set screws?

[Roadman]

The cheapest solution would be to buy a small section of threaded rod and cut it to length.

R/T Specialties MIGHT list them.  You'd end up spending more on shipping then you would for the parts though.

    quarter 20 allthread, easy, peasy.             

[blown motor]

I actually used 1 1/4" bolts and cut them just below the head. Then I jammed two nuts together to make a temporary head so I cold turn them in. I put the cut end down which left a factory finished end exposed so it looked correct and didn't look like a fixer upper job.

[Roadman]

   Awesome fixer up job Murray.         

[Brads70]

   I was thinking " what kind of farmer couldn't come up with a solution to this"

[blown motor]

  I was thinking " what kind of farmer couldn't come up with a solution to this"

Lol!
I can always come up with a solution but sometimes others have a better solution. That's why I ask. And sometimes someone's suggestion stimulates my thinking.

[Brads70]

  I was thinking " what kind of farmer couldn't come up with a solution to this"

Lol!
I can always come up with a solution but sometimes others have a better solution. That's why I ask. And sometimes someone's suggestion stimulates my thinking.

  oh I know it's just fun to  ya!   

Ian will be along soon!