71-Later Cuda Rocker Molding - Repro vs. Original?

[Floyd]

I have a set of rocker moldings off a 71 Barracuda.  Both sides have some sharp dents but are fixable according to the trim guy I use.  Are the repros good enough for most folks?  I've hear they don't fit as well as originals (too long).  Trying to decide to try to sell or recycle.  Restoration is probably going to run close to $250 for the pair.

Thanks

[anlauto]

I just ordered two sets of the later 73-74 moldings for the two 71 Cudas I'm working on from Roseville Moparts...From what I understand, they are only an inch or two shorter, which is good enough for the girls I go out with.

[Floyd]

So is 71 unique?  Do you know what the repros measure?  The ones I have are 74.75".

Thanks

[anlauto]

They should arrive this week, I'll let you know.

[anlauto]

@Floyd I just got my reproduction 73-74 Rocker moldings today from Roseville Moparts They are manufactured by OER and measure exactly 72" or 6 feet tip to tip 

[Floyd]

Thanks Alan.  Much appreciated.

[anlauto]

Does anybody have a Cuda that can measure the distance between wheel lip molding to wheel lip molding along the rocker ?
I betting it's real close to your 74 3/4" maybe 75" at most ?

[benguin]

Right at 74 3/4" molding to molding above the gill molding on my '70.

[anlauto]

Wow, thanks for the super fast response exactly what I thought it would be too, so I'll have 1 3/8" gap from my rocker molding to my wheel lip molding...I can live with that