Door glass help needed - 70 Challenger

[GerryThal]

I am now stuck on the quarter glass - all the pictures / posts I have seen have the Ebody quarter glass trim attached with 2 screws - well mine has 2 rivets... I suppose you have to drill out the rivets to replace the glass - but where do you get thereplacement rivets ?

[GerryThal]

Another question - I noticed on my passenger door glass that the slide bolts have an o-ring and two teflon washers on them. However my drivers door (Early 1970) didnt have these two items (o-ring & teflon washers)... do I need to "upgrade" the drivers door glass?   Thank you

[anlauto]

I am now stuck on the quarter glass - all the pictures / posts I have seen have the Ebody quarter glass trim attached with 2 screws - well mine has 2 rivets... I suppose you have to drill out the rivets to replace the glass - but where do you get thereplacement rivets ?

I just did a set of these for a 1971 Cuda and used regular pop rivets in from one side

[GerryThal]

Thanks again anlauto, should I use steel or aluminum rivets?

[Scooter]

Thanks again anlauto, should I use steel or aluminum rivets?

Is there any reason not to just use 2 screws? 

[GerryThal]

Does anyone happen to know where the parts on "reply 29" go?

Also, can someone tell me the specs on the fasteners for the horizontal track? One is a phillips head, and the other is a 1/4" bolt.... where can I purchase 1 each of these??

Thank you very much for your help !!

[anlauto]

I'm not sure what those in #29 are either

[Odin]

Is that what these are?
I got these in the window rebuild kit, and don't know where thy go...

No but I found what I needed and fixed it just in time.  Thanks!