Plymouth Cuda Hood Emblem holes 71-74'

[Topcat]

Anyone have the measurements on the outside corner of the Cuda' hood where the  Plymouth emblem is situated?

[anlauto]

If you look on the underside of the hood there should be cut outs in the under bracing where the holes go.

[Topcat]

If you look on the underside of the hood there should be cut outs in the under bracing where the holes go.

I would prefer to get the measurements.

Thank you

[BFM_Cuda]

Topcat,

Measured mine, with a tape measure lightly pulled against the side of the hood: first hole is at 1 1/2", second hole is at 4 3/8", third hole at 6 3/4".

From the front, the first hole is just shy of 1 1/16", second hole is 1 1/16", third hole is 1 1/8" from the front edge. They appear to be in line with each other, just slightly closer to the front edge near the side of the hood.

I will try to upload pictures...

Lay it out with tape and a pencil, and compare the pin spacing on your emblem. I would drill a very small pilot hole in the hood first and use those holes to check your emblem before drilling the final size.

[Topcat]

Thank you BFM_Cuda   

[Shoooter]

This is great,  thanks I needed these. I have a original emblem but its alittle worn. Who sells these aftermarket?

[JS29]

@Shoooter  check with @Mopar Dave  from roseville

[Shoooter]

 I just found mine and it us NICE! There isn't a gasket or anything that goes under it is there?

So the holes look like they line up with the front edge , the emblem should follow that edge as well? IIt shouldn't be  straight across ththe hood? If that makes sense

[GoodysGotaCuda]

Just an FYI they have stick on emblems that don't require holes.

https://www.ebay.com/itm/NEW-1970-74-Plymouth-Emblem-Tail-Panel-Hood-Header-Panel-Stick-On/402168353296?fits=Model%3ACuda%7CMake%3APlymouth&hash=item5da31a1210:g:UqQAAOSwUi5ecVxr

[Shoooter]

I never knew they offered those. Thanks