1971 cuda fc7 plum crazy 340 roller

[Pentastarnut]

If someone makes a deal on my 70 i'm heading your way !

[71CudaGA4]

Where is this car located?

[dbishop1113]

Edmond Oklahoma


Sent from my iPhone using Tapatalk

[JEJJ]

Was the fire wall replaced in the car?.....I don't see A/C on the fender tag?

[dbishop1113]

Not that I could tell, but I dont know much of the history


Sent from my iPhone using Tapatalk

[cuda hunter]

Do the stamps on the core support and cowl area match the dash vin and fender tag?  That would give a little incite into the firewall question.   

[dbishop1113]

I can look tomorrow, where am I looking at? 


Sent from my iPhone using Tapatalk

[HP_Cuda]

I'm guessing the motor and drive train are long gone.

If this was a four speed setup this would be long gone by now.

[JS29]

I'm guessing the motor and drive train are long gone.

If this was a four speed setup this would be long gone by now.

But the option of installing one is easy now at this stage. the original drive train is gone.  A ralley cluster, 4-speed, no console. 

[ec_co]

I can look tomorrow, where am I looking at? 


Sent from my iPhone using Tapatalk

radiator support: open the hood, radiator core support - @ 10-15" from center (towards the driver side) should be a stamped # matching the last of the VIN (might be under the yellow sticker if still there).
Cowl: look at the driver side vent hole - just a couple inches towards the driver side is stamped the last few of the VIN.

these are the only 2 areas stamped on the body of an e-body to match VINs to the dash/door/motor/trans VINs

[cuda hunter]

 

[dbishop1113]

Sent from my iPhone using Tapatalk

[dbishop1113]

Sent from my iPhone using Tapatalk

[dbishop1113]

Sent from my iPhone using Tapatalk

[dbishop1113]

Sent from my iPhone using Tapatalk