1973 Challenger L31 - fender hole locations

[6bblgt]

does anyone have the hole pattern & dimensions for the fender turn signal indicators for a '73 Challenger?        @Burdar

[Burdar]

Sorry, I do not.  That was one of the things I messed up on my car.  I had a 72 fender that I was going to use until I decided to use Goodmark fenders.  The body shop used that 72 fender to drill the fender mount turn signal holes.   

We had to use an air grinder to open up one hole to 73 size AFTER the car was painted.  The other hole was too large since 73 uses a screw to attach the turn signals instead of a stud/nut.  Since I couldn't use a screw I bought two philips head machine screws and used a nut to attach them.  They look correct from up top but they aren't attached correctly underneith.

[Shoooter]

Are the hole locations different from a 1970 challenger?

[Burdar]

Yes.  73 and 74 have one very large hole and one small hole for the attaching screw.

[three two barrels]

I can take some dimensions and measurements tomorrow from my 74 if that helps you.

[6bblgt]

I can take some dimensions and measurements tomorrow from my 74 if that helps you.

thanks, that would/should be the same! 

[three two barrels]

large hole is 11/16 diameter

[6bblgt]

those should work! thanks