70 Challenger Drivers Glass install help - Dallas referral

[Friscomail]

Folks,

If you can see some of my threads I replaced and updated the hardware for my drivers side window.  After many attempts I can't seem to get the glass to line up correctly.  I have found great threads in this forum but obviously still not doing something right.  I wanted to reach out to the forum to see if anyone knows someone in Dallas Texas that can swing by my shop and complete the install.  Any suggestions would be GREATLY appreciated!!!

I could also transport the car to someone's location if that is easier.

[anlauto]

Dumb question out of the way first...did you reinstall the regulator in the correct position ? Measure roughly where the widow crank is compared to the window crank hole in the door panel.

I only ask because it's possible to put a Cuda regulator in a Challenger position and vice versa and it will work, but the glass adjustment is way off....I only know this, because I've done it before

[Yeya93]

https://youtu.be/ZmEuHGKJu3E

There's a segment where they go in detail on how to adjust window on doors.  They even demonstrate it with door shell removed for better visuals. I hope that helps

Sent from my Pixel 5 using Tapatalk

[Friscomail]

thanks but I am sure its correct - compared it to the one I removed.  But thanks for the suggestion.

[Friscomail]

missed this one on YT - thanks.  Let me try again tonight? 

[anlauto]

thanks but I am sure its correct - compared it to the one I removed.  But thanks for the suggestion.

Yea, that's why I said it was a "dumb question", but I thought I would ask....it's really an easy mistake to make ...here's what I was talking about...simply put in the wrong hole... and it still works

[fc7cuda]

If you still need help, PM me your telephone 📞

Tom

[BFM_Cuda]

Yea, that's why I said it was a "dumb question", but I thought I would ask....it's really an easy mistake to make ...here's what I was talking about...simply put in the wrong hole... and it still works

For the 2nd day in a row, I learned something new on this site. Thanks Alan...   
Never realized there were two locations for mounting.

[GoodysGotaCuda]

I am over in near Denton, and unfortunately I struggled a bit with the installation of my window regulators.

As far as someone to take it to, you could ask Ward's body shop in Krum [just West of Denton]. They do quite a few Mopar paint jobs and might be able to work something like that in or have another reference for you to investigate. They are good people and they painted my 'Cuda for me a few years back.