Main Menu

voltage regulator

Started by cuda hunter, April 04, 2018, 07:58:43 PM

Previous topic Next topic

0 Members and 2 Guests are viewing this topic.

cuda hunter

67 barracuda 400 727 .
Voltage shows 18.  Switched to a different one I had in the garage.  Same voltage 18.

New battery in the rear is puking acid. 

Is the altenator bad or should I try a voltage regulator off of my known runner?

No stores are open out here and I work all day so it's hard to just go pick one up.  And they would have to be shipped in. 
"All riches begin as a state of mind and you have complete control of your mind"  -- B. Lee

dodj

First make sure your grounds are solid and all connections are clean and tight.  Voltage drops across poor connections can fool the vr into overcharging.
"There is nothing your government can give you that it hasn't already taken from you in the first place" -Winston Churchill

Chryco Psycho

More likely to be a bad diode in the Alt if 2 regs make no difference


cuda hunter

That's what I was thinking at this point.

When the motor blew, the shift point was about 7500 rpm.  Would that be enough to fry the alt? 
"All riches begin as a state of mind and you have complete control of your mind"  -- B. Lee

Chryco Psycho

NO , I ran my Duster to 7200  for years with no issue but the alt could still be bad