normal_post in Wiring Harness Connector & Wire Pulling Tight W/ Pic. in Electrical & Audio Author Topic: Wiring Harness Connector & Wire Pulling Tight W/ Pic.  (Read 437 times)

Offline Daveh

  • Trade Count: (3)
  • Six Pack
  • ****
  • Location: South Florida
  • Posts: 1023
  • Credits: 6290
    • Share Post
clip in Wiring Harness Connector & Wire Pulling Tight W/ Pic. in Electrical & Audio
Wiring Harness Connector & Wire Pulling Tight W/ Pic.
« on: September 11, 2018, 06:47:54 AM »
Hey Guys,

As you know in putting back the car I'm replacing the under dash wiring harness.  The previous owner spliced the hell out of it with household wire nuts.  I've been pretty meticulous about labeling and moving and attaching the smaller harnesses to the main under dash harness. 

However if you look in the picture one of the connectors and wire are pulling on each other where I'm concerned the brown wire may snap.  That's why I temporally put on the zip ties so as to not stress the wires until I figure this out.

1. Does the 2 grey connectors go together?  I thought I labeled them well but stuff happens.
2. What is that wired for?
3. Maybe they just get zip tied together so as not to stress that brown wire?
4. Where does the connector where the brown and orange wire go? 

As always any help is greatly appreciated.  Thanks for your help.

Dave

Linkback: https://forum.e-bodies.org/electrical-and-audio/11/wiring-harness-connector-and-wire-pulling-tight-w-pic/8396/

Offline Jay Bee

  • Trade Count: (0)
  • Six Pack
  • ****
  • index in Wiring Harness Connector & Wire Pulling Tight W/ Pic. in Electrical & Audio
  • Posts: 1662
  • Credits: 10740
    • Share Post
clip in Wiring Harness Connector & Wire Pulling Tight W/ Pic. in Electrical & Audio
Re: Wiring Harness Connector & Wire Pulling Tight W/ Pic.
« Reply #1 on: September 12, 2018, 05:26:20 AM »
The connectors you're talking about are radio related. Apparently you use the black connector with the brown and orange if you have the "radio with tape". If not, you separate the 2 grey plugs and your AM radio just plugs into the one with the 2 oranges and red w/white tracer. I edited a portion of the color schematics to show this.
1970 Barracuda convertible
2000 Toyota Avalon XLS

Offline Daveh

  • Trade Count: (3)
  • Six Pack
  • ****
  • Location: South Florida
  • Posts: 1023
  • Credits: 6290
    • Share Post
xx in Wiring Harness Connector & Wire Pulling Tight W/ Pic. in Electrical & Audio
Re: Wiring Harness Connector & Wire Pulling Tight W/ Pic.
« Reply #2 on: September 12, 2018, 08:02:01 AM »
Awesome that's perfect.  I'll unplug them since I'm installing an aftermarket radio.  Thanks again. 

E-Bodies Cuda Challenger Message Forum

xx in Wiring Harness Connector & Wire Pulling Tight W/ Pic. in Electrical & Audio
Re: Wiring Harness Connector & Wire Pulling Tight W/ Pic.
« Reply #2 on: September 12, 2018, 08:02:01 AM »

Tags:

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter Share via whatsapp

clip
Engine Wire Harness Individual Wire Needed

Started by schlett7nu1

8 Replies
605 Views
Last post October 03, 2018, 12:10:28 PM
by schlett7nu1
clip
What is this 3-wire connector coming from column?

Started by njsteve

7 Replies
381 Views
Last post November 22, 2020, 01:41:22 AM
by Caparco
xx
Rallye Gauge Wiring Harness VS Standard Harness

Started by Daveh

6 Replies
962 Views
Last post November 21, 2017, 08:27:10 AM
by Daveh
xx
Difference in radio to harness connector

Started by 72 Challenger

1 Replies
404 Views
Last post May 01, 2018, 11:19:44 AM
by Slotts
clip
Help identify three pin connector on column harness.

Started by TGGodfrey

5 Replies
362 Views
Last post October 08, 2020, 03:06:02 PM
by Fastmark