4-speed Reverse wiring harness

[usraptor]

Does anybody have a picture or diagram of how and where the reverse wiring harness is routed and attached to the A833 4-speed and bell house.  I believe there is one retaining clip at the 11 o'clock position on the bell housing.  However, even with that my harness hangs down below the trans.  I checked the service manual but it doesn't show anything regarding the harness other than where it attaches to the trans.  Thanks

[HP_Cuda]

Posted the answer over at the other place but here ya go...

There are two wire clips that attach to the top furthermost ends of the inspection cover.

You can make them out in this pic:
https://i.ytimg.com/vi/phRtePlYSbA/maxresdefault.jpg

http://www.ebay.com/itm/66-74-Mopar-A-B-C-E-Body-Cuda-Reverse-Wiring-Transmission-Clip-/381908108716?hash=item58eb7f45ac:g:AIIAAOSwMmBVzOXj&vxp=mtr

[usraptor]

Thanks HP!  It's very much appreciated! 

[HP_Cuda]

Not a problem, went thru the same problem not long ago.