Main Menu

Reverse light harness routing

Started by Sir Keppa, February 12, 2019, 01:28:59 AM

Previous topic Next topic

0 Members and 1 Guest are viewing this topic.

Sir Keppa

Hi everyone.
I just get a correct reverse indicator light with harness for the 4-speed trans. My car came factory with 3-speed and i wanted to complete the trans swap with the dash reverse light.
I am unsure about the routing of the harness now.
I know there should be two fork like clips at the transmission itself to hold the harness in place and maybe another standard clip somewhere at the bell housing...
I dont know where the clips go - it would be nice if someone can show a pic with the locations marked.
Are there clips in the engine compartment too?
Global is the new local!

Chryco Psycho

It should cross over the top of the trans where the tail housing bolts on , there should be 1 clip there  & comes up the right side of the trans away from the shift linkage up to the fire wall & joins the engine harness in the clips on the firewall over tot he fuse block area

Sir Keppa

Okay, i think where it joins the engine harness is clear for me.
I marked the two positions red in the picture where i suppose the two fork like clips should go.
The should be a third different style clip which goes on top of the housing then?
Global is the new local!


Shane Kelley

Here's some pics.

Sir Keppa

Thanks @Shane Kelley ! The pictures help a lot!
I suppose i spotted the third missing clip on top of the housing?
Global is the new local!

Chryco Psycho


Shane Kelley

Quote from: Sir Keppa on February 12, 2019, 03:02:34 PM
Thanks @Shane Kelley ! The pictures help a lot!
I suppose i spotted the third missing clip on top of the housing?
Yep.  That's it.