Reverse light harness routing

[Sir Keppa]

Hi everyone.
I just get a correct reverse indicator light with harness for the 4-speed trans. My car came factory with 3-speed and i wanted to complete the trans swap with the dash reverse light.
I am unsure about the routing of the harness now.
I know there should be two fork like clips at the transmission itself to hold the harness in place and maybe another standard clip somewhere at the bell housing...
I dont know where the clips go - it would be nice if someone can show a pic with the locations marked.
Are there clips in the engine compartment too?

[Chryco Psycho]

It should cross over the top of the trans where the tail housing bolts on , there should be 1 clip there  & comes up the right side of the trans away from the shift linkage up to the fire wall & joins the engine harness in the clips on the firewall over tot he fuse block area

[Sir Keppa]

Okay, i think where it joins the engine harness is clear for me.
I marked the two positions red in the picture where i suppose the two fork like clips should go.
The should be a third different style clip which goes on top of the housing then?

[Shane Kelley]

Here's some pics.

[Sir Keppa]

Thanks @Shane Kelley ! The pictures help a lot!
I suppose i spotted the third missing clip on top of the housing?

[Chryco Psycho]

true

[Shane Kelley]

Thanks @Shane Kelley ! The pictures help a lot!
I suppose i spotted the third missing clip on top of the housing?

Yep.  That's it.