Gooseneck to fuel tank seal

7E-Bodies · September 04, 2019, 10:42:26 AM

Can someone tell me/show me what the seal looks like here where the gooseneck enters the fuel tank?

shawge · September 04, 2019, 10:54:33 AM

Looks like this

7E-Bodies · September 04, 2019, 11:00:53 AM

That helps a ton. Previous owner gave me a boat load of new parts. Now I know what to look for. Thanks!

chargerdon · September 04, 2019, 12:13:53 PM

When i installed mine on a new tank, it leaked when i filled the tank.

I then drained tank and did it over this time putting plenty of black RTV on each grove of the seal, and then after inserting the filler tube, put plenty of Black RTV around the tube against the seal.. Then i let it sit for 24 hours before putting in gas and it held.

I don't know if this was just my problem or a common issue or whether there is a special sealant to use with it.

anlauto · September 04, 2019, 12:20:47 PM

You shouldn't have to use any type of sealer with it.

Maybe a little lubricant would help installation

Dakota · September 04, 2019, 12:50:35 PM

The thicker portion of the seal goes inside the tank. I trashed the grommet during my first attempt to get the pipe through it, even with Vaseline on everything. On the 2nd attempt, warmed up the grommet in hot water (soaked about 10 min) before putting it in the tank to soften it a bit and still used Vaseline. Things went much better on the 2nd try.

7E-Bodies · September 04, 2019, 03:24:40 PM

Great advice!

tparker · September 04, 2019, 04:17:06 PM

@anlauto did you mean "shouldn't"?

Brads70 · September 04, 2019, 04:23:16 PM

Quote from: anlauto on September 04, 2019, 12:20:47 PM
You should have to use any type of sealer with it. Maybe a little lubricant would help installation

"Shouldn't"

RTV silicone should never be used with gasoline. Turns to jelly....

anlauto · September 04, 2019, 05:15:53 PM

Quote from: Brads70 on September 04, 2019, 04:23:16 PM
Quote from: anlauto on September 04, 2019, 12:20:47 PM
You should have to use any type of sealer with it. Maybe a little lubricant would help installation

"Shouldn't" RTV silicone should never be used with gasoline. Turns to jelly....

YES, Brad thanks for pointing that out...some times you think one thing but type another

Topcat · September 04, 2019, 09:04:19 PM

Quote from: 7E-Bodies on September 04, 2019, 11:00:53 AM
That helps a ton. Previous owner gave me a boat load of new parts. Now I know what to look for. Thanks!

Vaseline the seal prior to tube insertion. (that's a no brainer) Right?

As you tighten the tank up higher, take a break and slowly lower fill tube in.

2 or 3 times should be fine.

Gas Tank Seal, & Trunk Floor Seal Package Deal Started by 340challconvert on Parts / Misc For Sale	3 Replies 740 Views	Last post: October 27, 2021, 09:12:35 AM by 340challconvert
Fuel leak right rear corner of fuel tank area. Started by Racer57 on Engine, Transmission & Rear End	4 Replies 709 Views	Last post: July 21, 2022, 06:47:45 PM by Ccuda
Fuel Pump for Fuel Injection & Tank for 70-74 Barracuda/Cuda Started by SW mopar on Parts / Misc For Sale	0 Replies 83 Views	Last post: January 21, 2025, 11:43:23 AM by SW mopar
Fuel Tank Started by tdwnilla1 on Cuda & Challenger General Discussion (ROSEVILLE MOPARTS)	5 Replies 827 Views	Last post: May 24, 2022, 04:31:22 PM by moparroy
Fuel Tank new Started by vilzrod on Parts / Misc For Sale	2 Replies 1390 Views	Last post: March 19, 2018, 12:57:52 PM by anlauto