What's your favorite factory hood

[Brads70]

I remember wanting a power bulge hood on my first Challenger so bad but couldn't find one. (80's)
What's your favorite? I'd say the AAR design wise is my favorite.

[Chryco Psycho]

 

[RUNCHARGER]

They're all cool other than the flat hoods. I prefer the Challenger R/T hood much more than the Cuda hood though. I also prefer the T/A over the AAR hood although the AAR gets points for being unique.

[cataclysm80]

I'd have to pick a functional hood scoop over any decorative scoops, as long as it isn't a lift off hood because those are difficult to handle by yourself.  That narrows it down to shaker, T/A & AAR.

I've read quite a few places that say the T/A hood works better than the AAR hood because it gets the air from above the boundary layer.

Also, the T/A hood is less likely than the AAR to have water pour into the scoop while driving in a rainstorm.

I think the T/A hood is more unique than the AAR hood.
Aren't there a lot of Camaros with scoops similar to an AAR?

Shaker hood is OK also. 
It might be more work to get to the carburetors with a shaker, if you're planning to make frequent adjustments (racing), but I don't mess with my carbs much.

An organisol T/A hood will probably grab more attention than a body color shaker hood, just due to the contrast of the color difference on the large surface area of the hood.

[fc7cuda]

They're all cool other than the flat hoods. I prefer the Challenger R/T hood much more than the Cuda hood though. I also prefer the T/A over the AAR hood although the AAR gets points for being unique.

I also like the shaker hood quite abit and definitely would prefer that on any 440-6 or Hemi cars.  Especially when you have a good cam and it actually "shakes" 

Tom

[ec_co]

T/A hood 1st, AAR next and Shaker 3rd for me

[anlauto]

I only like an AAR hood on an AAR....
I only like a T/A hood on a T/A....
I only like a Shaker hood on an original N96 car.....

You can see where I'm going with this.....

I like all the hoods...

[kdcarman]

I only like an AAR hood on an AAR....
I only like a T/A hood on a T/A....
I only like a Shaker hood on an original N96 car.....

You can see where I'm going with this.....

I like all the hoods...

[303 Mopar]

I only like an AAR hood on an AAR....
I only like a T/A hood on a T/A....
I only like a Shaker hood on an original N96 car.....

You can see where I'm going with this.....

I like all the hoods...

  The only exception is a flat hood.  They just don't look right on an e-body and I would have to switch it out to a 2 scoop hood.

[HP_Cuda]

Heh the raisin bran hood.

Two scoops!!!

[6bblgt]

I only like a T/A hood on a T/A....

[Cuda Cody]

You could get T/A on a non T/A Challenger from the factory, but could you also get an AAR hood on a non AAR?

I only like a T/A hood on a T/A....

[6bblgt]

You could get T/A on a non T/A Challenger from the factory, but could you also get an AAR hood on a non AAR?

I only like a T/A hood on a T/A....

no, not a factory OPTION

[anlauto]

I only like a T/A hood on a T/A....

Ok ok ok....I hear you loud and clear

[Cuda Cody]

If I could vote Twice, the Shaker is #1 for me but a SUPER close 2nd is the T/A Hood.