440 Six Pack emblem hole locations on shaker scoop

ksierens · August 19, 2017, 11:49:43 AM

Does anyone have information about the hole locations for the 440 Six Pack emblems on a shaker scoop? I know they are tapered, so I am guessing the have to be in the right position.

6bblgt · August 19, 2017, 11:54:30 AM

I thought ALL SHAKER 3-pin emblem holes had the same location??

Cuda Cody · August 19, 2017, 12:34:33 PM

I thought they were all the same location too, but the emblems have a taper to them so they fit the shaker.

ksierens · August 19, 2017, 12:37:49 PM

Oh that would be good then, I have not bought the emblems yet, so I was just looking for the information now.

Thanks

70 Challenger 3 pin Fender emblem hole locations Started by Marksmopar1 on Body Shop	9 Replies 3209 Views	Last post: December 10, 2018, 10:19:33 PM by 6bblgt
Challenger R/T hood emblem hole locations Started by wanderlustin on Cuda & Challenger General Discussion (ROSEVILLE MOPARTS)	4 Replies 907 Views	Last post: April 02, 2021, 03:10:21 PM by wanderlustin
440 six pack Shaker emblem Started by Roweld on Parts Wanted	4 Replies 626 Views	Last post: March 10, 2023, 11:51:45 AM by Mr Cuda
Hood hinges hole locations Started by Indiana Challenger Guy on Body Shop	9 Replies 327 Views	Last post: August 11, 2025, 03:51:02 PM by Indiana Challenger Guy
emblem placement on 2 scoop cuda hood Started by 1970 cuda Joe on Body Shop	3 Replies 794 Views	Last post: April 15, 2024, 04:55:18 PM by 1970 cuda Joe