wheel puller

[71-440]

I need to pull the crush can to get to the turn signal switch. The turn signal arm went limp....lol
I am hoping the screw came loose. It looks like I need a puller with at least a 5" long 3/8-16 bolts to get in there.
Is that correct?

Thanks!

[Cuda Cody]

I've used this one without any issues.

[Cuda Cody]

Just looked at the receipt.  Paid $12.69 in April of 2001 for it.   

[Jim AAR]

Here's the same one on E-Bay $17.99 US

https://www.ebay.com/itm/Napa-Evercraft-Steering-Wheel-Puller-775-3900-/322656507283

[anlauto]

I use a very similar one, but swapped out the bolts for two pieces of threaded rod/nuts to reach down inside the crush can

[71-440]

Thanks Cody!

[71-440]

Thanks Guys!
I saw that one on e-bay.
Picked one up locally for 18.99. Not the NAPA one.
Might need threaded rod like Alan said to reach down inside the can.

Thanks for the help!

[71-440]

Got the signal arm fixed. The screw loosened up. I put a dab of lock-tite on it and tightened it up.
I didn't realize there was a wide spline on the can and shaft.

Thanks to Cody's video I watched on reassembling the steering column
it went back together with no problems.

I did get some threaded rod from HD like Alan suggested.

Thanks everyone for the help.