Brake Cable To Firewall Grommet

[Mrbill426]

Ok, so maybe if they are not part of a molded-in washer the re-op could be stretched over the end of the assembled cable.

On my original grommet, the rubber was molded around the metal prongs.  On the reproduction, the prongs just stick out of the rubber.

[HEMICUDA]

If you're looking for an exact reproduction, I made them for Fine Lines.  However, I think Bob sold is remaining inventory to Jim at Detroit Muscle Technologies.  I even had the "H" & "B" molded into them.  The easiest way to install them on new cables is boil a cup of water and throw the grommet in, grease the end of the cable and you'll get it on.  All originals have a metal ring with the tabs stamped into it.  Two of the three tabs are bent to hold the grommet in and the other was used for alignment.