1970 Challenger Restomod

[ToxicWolf]

Here is a picture of the button that works the e-brake.  This is a picture of my center console where I put a plate for buttons and switches.  The round green button is used to engage and disengage the e-brake.  When you push it, the button flashes until the action is complete.  You can mount this button anywhere in the car you want. 

[blown motor]

@ToxicWolf  Jim, do you have the transmission out of the car again?

[Convertcuda]

Nice job on the resto. Could you show us pictures of how ran the fuel lines from to back? Please include the whole route with fuel filter. I'm building a resto mod and looking for ideas.

Thanks Ken

[ToxicWolf]

@ToxicWolf  Jim, do you have the transmission out of the car again?

Not yet. But it's on the list.

[ToxicWolf]

Nice job on the resto. Could you show us pictures of how ran the fuel lines from to back? Please include the whole route with fuel filter. I'm building a resto mod and looking for ideas.

Thanks Ken

Soon as I get her up in the air again I'll do it.  Could be awhile though. 

[dodj]

I installed a E brake this summer but didn't get to try it , I made brakets & mounted off the belhousing  & trans for rigidity

Having a tough time visualizing how you mounted that estopp on the bell housing?

[YellowThumper]

Very cool.   

[Chryco Psycho]

I installed a E brake this summer but didn't get to try it , I made brakets & mounted off the belhousing  & trans for rigidity

Having a tough time visualizing how you mounted that estopp on the bell housing?

where the trans bolts onto the belhousing I built a bracket to hold one end of the e stopp , the other end where the cable is I built a second bracket from the trans mount which pulled the 2 long cables coming from the rear wheels using a balance plate , it could also be used to pull a main loop cable connecting to the short cables at each wheel

[dodj]

I installed a E brake this summer but didn't get to try it , I made brakets & mounted off the belhousing  & trans for rigidity

Having a tough time visualizing how you mounted that estopp on the bell housing?

where the trans bolts onto the belhousing I built a bracket to hold one end of the e stopp , the other end where the cable is I built a second bracket from the trans mount which pulled the 2 long cables coming from the rear wheels using a balance plate , it could also be used to pull a main loop cable connecting to the short cables at each wheel

OK. Thanks.
I asked toxic to post a pic of his because I'm planning on buying one,  but having a hard time deciding the best placement.
Definitely another option i hadn't thought of.