Main Menu

Heater Delete box

Started by cuda hunter, May 24, 2020, 02:31:59 PM

Previous topic Next topic

0 Members and 1 Guest are viewing this topic.

VCODE

Quote from: 6bblgt on May 24, 2020, 05:12:29 PM
looks the same  :takealook:  still has the diverter attached, made of the same stuff as glove box liners

Yes Dan, Same box and bracket even with the cardboard diverter. Those did not last long.
Bob

cuda hunter

And a few pics of a cleaner bracket for reference. 

"All riches begin as a state of mind and you have complete control of your mind"  -- B. Lee

ec_co

.... you could always ask someone to have it replicated, it doesn't look like that hard of a piece to do .... initial cost would suck a little, but enough folks and it brings the cost way down (3d scan, either 3d print or machined/cut, or just cut some metal and bend it in a couple spots) or sell a few after the fact to recover the cost. make it obtanium
Growing older is mandatory...growing up is optional.

Be who you are and say what you feel, because those who mind don't matter and those who matter don't mind.

'70 Barracuda B5/B5 225 /6 3spd ... about as bare bones as they came


cuda hunter

That is a possibility.  The hardest part wold be that mount that goes to the dash frame.  Would have to actually hold one and have it sit on a shelf at a fab shop until a master could work it up for me. 
"All riches begin as a state of mind and you have complete control of your mind"  -- B. Lee