Roseville sheetmetal

[whitsend]

Looking at the sheet metal on Roseville's site, It appears that the only difference in the trunk floor between the Cuda' and Challenger is the filler neck location.
It also appears that the floor under the rear seat is the same.
I know the Cuda' is a shorter wheelbase. Where is the difference in the two for length?

Could one order the trunk/underseat section for the challenger with the frame rails attached, change the filler neck cutout to the Cuda' and use that for a Cuda' replacement?

Is the roof panel the same?

What I'm getting at is, would it be possible to build a complete Cuda' body using aftermarket parts if you had a jig?

Has anyone ever tried this?

 

[anlauto]

the 2" wheel base difference is in the rear foot well pans.
Yes, you can put the Challenger rear rail/trunk/center floor pan assembly, change the filler location, into a Cuda.
Roof panel is TOTALLY different.

[whitsend]

the 2" wheel base difference is in the rear foot well pans.
Yes, you can put the Challenger rear rail/trunk/center floor pan assembly, change the filler location, into a Cuda.
Roof panel is TOTALLY different.

So the front and rear frame rails are the same length? The only difference is the rear foot well panels?
I have watched the video where they take a shell and put all new AMD parts and weld them on.
I'm just wondering if someone wanted to put the work into it,
is it possible to build a Cuda' body Like the Challenger body for sale on Roseville's site just from AMD/reproduction parts?  Thanks Alan   

Dan

[anlauto]

I don't think all the internal structural parts are available

[whitsend]

Thanks for the replies Alan!

[Rich G.]

I agree, I think the only thing you can't get it the part under the roof and sides. Don't know what that section is called.

[RUNCHARGER]

Has anyone used these yet?

http://www.dynacorn.com/ShowItem.aspx?item=6098WT

[71GranCoupe]

I have picked up both the left and right package as shown and happy with the appearance and fit. It says for Challenger, but as far as I know, these parts will fit both models.

[cuda hunter]

Has anyone used these yet?

http://www.dynacorn.com/ShowItem.aspx?item=6098WT

and would that work for a cuda? 

[71GranCoupe]

Has anyone used these yet?

http://www.dynacorn.com/ShowItem.aspx?item=6098WT

and would that work for a cuda?

Not without having to alter the rear curved window to the sharper angled corner that is on a Cuda/Barracuda. 

[anlauto]

Has anyone used these yet?

http://www.dynacorn.com/ShowItem.aspx?item=6098WT

and would that work for a cuda?

It's also 2" longer then a Cuda