Engine, Transmission & Rear End

Edelbrock Gen II Hemi Heads        http://www.rodauthority.com/tech-stories/engine/improving-legendary-performance-with-edel...

Started by RoadmanView the profile of Roadman

Replies: 1
Views: 910

February 24, 2017, 01:31:07 PM
by Brads70

Jim Ridge Starter Restoration (Dixie Restorations) Jim did a starter restoration for me and here's the photos.  I really like the attention to detail a...

Started by Cuda CodyView the profile of Cuda Cody

Replies: 12
Views: 2,715

February 24, 2017, 09:45:54 AM
by Brads70

Choosing a New Manual Transmission I am looking to convert my '70 Cuda from a 727 to a manual transmission and would like input on my o...

Started by 303 MoparView the profile of 303 Mopar

Pages1 2

Replies: 25
Views: 5,961

February 18, 2017, 09:49:31 AM
by chal340

Z bar question Can somebody please explain the purpose of this clip (circled) on the Z bar.  I can't see that it do...

Started by usraptorView the profile of usraptor

Replies: 7
Views: 1,826

February 17, 2017, 07:09:32 PM
by Chryco Psycho

Stupid!,Stupid!, Stupid! So today I'm trying to re-install my engine and transmission by myself.  I lowered the car down over...

Started by usraptorView the profile of usraptor

Pages1 2 3

Replies: 31
Views: 2,896

February 17, 2017, 11:51:07 AM
by usraptor

Vacuum canister obstructed by oil sending unit Can anyone tell me what is wrong with this picture? Original points distributor vacuum canister is h...

Started by Aar1064View the profile of Aar1064

Pages1 2 3

Replies: 37
Views: 3,936

February 17, 2017, 07:58:17 AM
by RUNCHARGER

Gapless Piston Rings     Well, I learned something from this, seems they have been around for awhile. Anybody ever use th...

Started by RoadmanView the profile of Roadman

Replies: 6
Views: 1,119

February 16, 2017, 08:05:31 PM
by Chryco Psycho

Manifold / carburator Thermoquad vs Demon Hello, I need some advices here The 340 ci motor in my 71 Challenger R/T has been rebuilt during a r...

Started by automate33View the profile of automate33

Replies: 9
Views: 1,696

February 16, 2017, 10:07:20 AM
by HP_Cuda

K-Member identification location Hello everyone, I am in the process of a total restoration of my 70 Cuda. Can anyone tell me where I...

Started by Car-nuttView the profile of Car-nutt

Replies: 12
Views: 8,810

February 15, 2017, 05:31:22 PM
by usraptor

B

TDC, Distributor Gear an Distributor Installation Question Hi Guys,I'm trying to install my distributor on my 340 and I have been going through the following s...

Started by DavehView the profile of Daveh

Replies: 12
Views: 9,067

February 08, 2017, 02:10:41 PM
by Burdar

C

Installing a sound system in 73 Cuda Does anybody have any suggestions, ldeas, or pictures of their sound system set up? I am completely ...

Started by CudalbsView the profile of Cudalbs

Replies: 10
Views: 3,263

February 08, 2017, 11:14:44 AM
by cataclysm80

Small Block Valve Covers Value With Pictures Hey guys is there any value to these small block valve covers?  Thanks

Started by DavehView the profile of Daveh

Replies: 6
Views: 1,235

February 08, 2017, 05:43:29 AM
by Daveh

677 stamp paint I finally received my 677 stamps for my 4-speed trans but they didn't come with any paint or stamp p...

Started by usraptorView the profile of usraptor

Replies: 10
Views: 1,781

February 07, 2017, 07:09:54 PM
by usraptor

Which direction to advance timing on a small block 340? Looking at the engine from the front of the car, Which direction do I turn to advance the timing on ...

Started by nsmallView the profile of nsmall

Replies: 2
Views: 5,748

February 07, 2017, 04:03:55 AM
by fc7cuda

Stock Electronic Distributor Wiring Question Hey guys,I need to splice in my old stock electronic distributor to my new distributor and the wire ...

Started by DavehView the profile of Daveh

Replies: 11
Views: 1,687

February 06, 2017, 08:00:36 PM
by Cuda Cody

cylinder crosshatching Roughly, how many  miles could be on a block since a build if crosshatching is clearly visible?

Started by ChallengerHKView the profile of ChallengerHK

Replies: 6
Views: 2,636

February 04, 2017, 04:01:26 AM
by ChallengerHK

5.9 Magnum - what manual trans? What 5 speed would have come behind, say a Dakota, with a 5.9 Magnum? What kind of reputation does i...

Started by ChallengerHKView the profile of ChallengerHK

Replies: 3
Views: 1,366

February 04, 2017, 03:57:47 AM
by ChallengerHK

4 Hole Plenum VS. Open Plenum Question Hi Guys,I ordered some spacers for my small block MOPAR and instead of the open plenum I accidently ...

Started by DavehView the profile of Daveh

Replies: 10
Views: 1,419

February 03, 2017, 08:21:00 PM
by Cudakiller70

Air Grabber conversion I'm getting a TA hood, but I'll be going with a single 4 bbl. An idea I've been toying with for a wh...

Started by ChallengerHKView the profile of ChallengerHK

Replies: 6
Views: 1,241

February 03, 2017, 10:18:32 AM
by RUNCHARGER

4 Speed Trans ID Hello everyone, this is my first post.I've attached a picture of the 4 speed trans that came with my...

Started by Car-nuttView the profile of Car-nutt

Replies: 7
Views: 1,753

February 03, 2017, 09:47:55 AM
by HP_Cuda