Engine, Transmission & Rear End

Looking For A New Intake For My Shaker Challenger Hi Guys,I'm looking for a new aluminum intake for my shaker 1970 Challenger.  As some of you may hav...

Started by DavehView the profile of Daveh

Pages1 2

Replies: 21
Views: 3,897

January 24, 2017, 05:59:27 PM
by Chryco Psycho

Sending some 4-Speeds to Brewers Going to send a bunch of 4-Speeds to Brewers next week.  Need to get them all on a pallet and ready ...

Started by Cuda CodyView the profile of Cuda Cody

Pages1 2

Replies: 20
Views: 3,987

January 22, 2017, 12:54:50 PM
by 303 Mopar

Fuel line vendor suggestions I'm converting to FiTech EFI and need to buy new fuel and vent lines.Any preference between Fine Lin...

Started by KatfishView the profile of Katfish

Pages1 2

Replies: 17
Views: 3,681

January 18, 2017, 06:52:16 PM
by Katfish

Optimal 360 stroker set up @Brads70 and @Chryco Psycho For our 65 Barracuda strip/street we've debated s/c, turbo, NOS, etc for...

Started by Marc70challengerView the profile of Marc70challenger

Replies: 14
Views: 3,288

January 18, 2017, 03:33:41 AM
by Marc70challenger

what are the right tools... ... to check cylinder bore and crank journal diameter?  Any good or bad brands and models?

Started by ChallengerHKView the profile of ChallengerHK

Replies: 3
Views: 2,140

January 16, 2017, 09:12:23 AM
by ChallengerHK

A

340 positive battery cable install I never installed this cable and I was wondering if I have it routed to starter correctly. Picture m...

Started by Aar1064View the profile of Aar1064

Replies: 9
Views: 2,884

January 14, 2017, 06:16:12 PM
by Aar1064

440 Six Pack linkage and hardware kits - best source? I've got these beautiful carbs for my 70 440 and the right dated intake but no hardware!  I've casua...

Started by wanderlustinView the profile of wanderlustin

Replies: 9
Views: 8,929

January 11, 2017, 08:16:15 AM
by anlauto

4-speed Reverse wiring harness Does anybody have a picture or diagram of how and where the reverse wiring harness is routed and att...

Started by usraptorView the profile of usraptor

Replies: 3
Views: 3,001

January 10, 2017, 11:39:41 PM
by HP_Cuda

Valve Body screws Hi,I'm attaching my valve body and need to know all the correct screws neede.  I have not found any ...

Started by fc7cudaView the profile of fc7cuda

Replies: 2
Views: 1,943

January 05, 2017, 09:01:10 AM
by fc7cuda