Main Menu

type of screw in exhaust hanger plate?

Started by Dakota, July 31, 2019, 02:40:42 AM

Previous topic Next topic

0 Members and 2 Guests are viewing this topic.

Rdchallenger

Quote from: anlauto on September 25, 2019, 03:21:31 PM
Personally...I do not drill those holes until I install the exhaust....There's just too many variables during assembly....That's just my opinion though... I've got messed up before.

Seeing this just saved me from drilling mine before epoxy and paint as well.

anlauto

Exactly what I do, especially with Cudas where tip clearance is at a minimum  :alan2cents:
I've taught you everything you know....but I haven't taught you everything I know....
Check out my web site ....  Alan Gallant Automotive Restoration

Wayne

getting ready to install my exhaust...glad I came across this thread. 

My car was missing the trunk support pieces. I am just going to make them.  Can anyone please tell me what size they are?  I was going to make them 2" x 5.5" based on the depression of the trunk pan but after seeing these photos I think 5.5" would be too long. 
1970 Cuda 383 4spd red on red
Backyard Hotrods @ Youtube, Facebook & Instagram
https://www.youtube.com/channel/UC2bd5dyuOKCJT-kWhdEGm3A


Dakota

The plate is 4.5" x 2.0".   The center of the bolts are each 3/8" in from the short edge. 

1 Wild R/T

Quote from: VCODE on August 01, 2019, 03:33:11 PM
Untouched 70 Challenger R/T SE screw installed in upper left hole. SPD Nov 70
Oh and no sealer at all.
Bob

Bob, that must be the absolute latest production date for any 70 MY Challenger.... :pokeeye: :pokeeye:

Other than than the screw in the corner is what I 've seen, if there's a screw at all...