Water valve clip

[HP2]

I am putting the engine bay back together in my '74. I'm assembling the heater hoses and water valve. Looking at the cable, it has a loop in the end of it that I thought would fit over the lever on the valve, but if I use this, the travel on the valve doesn't match the travel of the slide in the dash. Reading the FSM, it mentions a retaining clip that holds the cable on the water valve. I assume this would allow the cable to be centrally positioned to allow the proper travel in the dash. Since I don't have one of this, it must have been missing since I bought the car. I must not be searching the correct terms as I can't find this clip on some of the resto parts websites.

Anyone have a picture of what this clip would like like in place or a line on a part number for a replacement?

[Bullitt-]

  I remember this suggestion from Detroit Muscle Technologies
https://forum.e-bodies.org/index.php?msg=329657

https://www.detroitmuscletechnologies.com/mopar-heater-control-cable-clip-air-grabber-cable-clip-shaker-cable-clip-6015143/

[screamindriver]

This is the one for the actuator AC cable adjustment ...cable clip   What's crazy about that listing is it's a pic of my car with the clip installed...lol.. He's been using it for years in his add...It's showing the bakelite valve but if your metal valve has a similar metal tab it will work...

[HP2]

I remember this suggestion from Detroit Muscle Technologies
https://forum.e-bodies.org/index.php?msg=329657

https://www.detroitmuscletechnologies.com/mopar-heater-control-cable-clip-air-grabber-cable-clip-shaker-cable-clip-6015143/

Thanks, that is a retaining clip to hold the cable. My valve has that built into it. I need the clip that adapts the cable to the lever.

This is the one for the actuator AC cable adjustment ...cable clip   What's crazy about that listing is it's a pic of my car with the clip installed...lol.. He's been using it for years in his add...It's showing the bakelite valve but if your metal valve has a similar metal tab it will work...

I think that's it! I have the metal valve but it appears to have the issue with holding the cable sleeve to lever interface issue as the bakelite valve. Thanks!

[HP2]

Picked up that package of clips. It was the part I was missing. It allowed me to align the cable sheath at a point it will clip into the  retainer slot on the metal valve and still get the cable attached to the valve arm at a location that allows motion of the temp lever to the valve lever.

Thanks for the recommendation!