LCA bumper clearance?

[Mrbill426]

Wondering is there a ballpark clearance between the lower control arm rubber bumper and the pad on the frame rail?  I am pretty sire I have the front-end height adjusted properly by the book but it looks pretty tight in there...   both sides are about the same.

[headejm]

Nor sure about a specific clearance but here is my passenger side clearance. About 1/2".

Don't forget if you have 15" wheels there is a spacer between the bumper and the LCA.

[Mrbill426]

@headejm I went from the stock 14" Road Wheels to 15" Ansen Sprints... so If I put a spacer in there the gap would be even tighter, or no gap at all. 

Nor sure about a specific clearance but here is my passenger side clearance. About 1/2".

Don't forget if you have 15" wheels there is a spacer between the bumper and the LCA.

[headejm]

Here's the driver's side from the rear showing the spacer installed. Same clearance as the passenger side.  I also noticed your bumper is closer to the engine than mine is. Not sure what that means.

[Cudajason]

Wondering is there a ballpark clearance between the lower control arm rubber bumper and the pad on the frame rail?  I am pretty sire I have the front-end height adjusted properly by the book but it looks pretty tight in there...   both sides are about the same.

is your car on the ground or on Jack stands in that picture.

I have found the ride height changes when the car is on jack stands.

[MoparLeo]

Here is the procedure from the Factory Service Manual for any of you that may want to know.

[Mrbill426]

All tires on the floor.

is your car on the ground or on Jack stands in that picture.

I have found the ride height changes when the car is on jack stands.

[Mrbill426]

Thanks.  Yes I have an FSM and that is the procedure I followed to adjust the front end height.  I will double check it and report back.

Here is the procedure from the Factory Service Manual for any of you that may want to know.