Cuda vinyl top trim position

[Tony 73]

Hi.
Sail panel has had trim holes welded over so I need to get measurements to get trim in correct position. I did a search on the forum and there was some helpful info.
I see the trim is level with the drip rail trim and someone said it has around 1/4 inch gap.
A photo or measurement of the distance between the window trim and vinyl top trim would be very helpful.
I assume if I get both ends in correct position then the middle section just needs to be parallel with the window trim.
Thanks
Tony

[fc7cuda]

Can you see the welded up holes from underneath?

[anlauto]

I think you're on the right track, it should lay comfortably on the car parallel to the window trim

[Tony 73]

I can see a couple from the underside but not enough to help.

Found a great drawing on this forum for challenger holes ( 14 holes) but I think cuda has less as I saw a photo of a 71 being stripped and looked like 12.

As you say, get it to lay flat and parallel with window trim.

Close up photo of a 70/71 vinyl/window trim be great.

Thanks for replies

[anlauto]

 

[soundcontrol]

Mine has never been removed.

[Tony 73]

 
Excellent photos.
cheers