Ignition switch wire removal for A01

[HUSTLESTUFF]

It's been a while since taking out the wires from the plug. Any help Cody

[Cuda Cody]

The A01 light does not go in that wire loom.  It's a separate wire that connects by itself.

If you need to get those wires out of that connector piece, you can use a wire terminal tool:

https://www.amazon.com/Lisle-57750-Wire-Terminal-Tool/dp/B007WQQHA2

Or use a small screw driver and press the tab down that hold them in.  Either way works pretty much the same.  If you need to re-install the wire all you have to do is lift the little metal tab up and it clips right back in.

[Cuda Cody]

You can see the little tabs in this photo:

[1 Wild R/T]

The round terminals are harder to remove from the connector without something like the proper tool... A screwdriver is bulky & you have two tabs to release...   Instead see if you have an old ball point pen, the with a brass ink cartridge.. The tube can be slide between the connector & terminal & that releases the lock tabs..

[fc7cuda]

The round terminals are harder to remove from the connector without something like the proper tool... A screwdriver is bulky & you have two tabs to release...   Instead see if you have an old ball point pen, the with a brass ink cartridge.. The tube can be slide between the connector & terminal & that releases the lock tabs..

Good idea