Challenger drive shaft

[truckinman466]

Looking for a slip yoke or complete drive shaft for a 727 transmission on a challenger

[fc7cuda]

Do you know the driveshaft center to center length of what's needed for your application?  I have some extra and would be glad to help. 

[truckinman466]

I don't have a measurement.I have this on a test stand. I just need to plug the rear of tranny so I can start it.

[RUNCHARGER]

Even a short slip yoke out of a 904 will work.

[truckinman466]

I have one from a 904. It is way too small

[Katfish]

I have a yoke for a 727, might take a little bit to find.
How much of a hurry are you?

[GoodysGotaCuda]

You likely want to call out which rear axle ujoint size you need as well. I may still have a new driveshaft that was bought for my dad's 72 318/727/8-3/4 challenger around. I'll look

[RUNCHARGER]

" have one from a 904. It is way too small" Whoops, yes you're right. Any from a 727 or A833 will work, sorry about that. Big Chrysler etc. will work for you.

[truckinman466]

Thanks everyone. I found one.