Back glass reveal molding clip mounting

[Mrbill426]

The replacement rear deck filler panel for our Cuda did not come pre-drilled for the reveal molding clip screws, and the old panel is long gone...  Does anyone have their back glass out that can measure the distance from the top surface down to the center of the screw holes, or does anyone know the answer right off?   I don't want to just "assume" it is the same distance as the side and upper molding clip mounting "pins" are without asking. 

Also are there actually eight clip positions across the bottom as indicated in the illustration @E-bodies.org, and are they equally spaced?

Thanks!

[anlauto]

The clip should end up flush, or just below the roof

[Mrbill426]

@anlauto , and flush or just below the filler panel top surface too?  That's the area I am concerned with.

Thanks

The clip should end up flush, or just below the roof

[anlauto]

Should be the same all the way around

[Mrbill426]

@anlauto ok thanks.
Should there be eight evenly spaced clips across the bottom like the illustration shows?

Should be the same all the way around

[anlauto]

Picture posted is of a Challenger, but I'm sure they are similar 

[Bullitt-]

  I see 6-trim clips + 2 centering clips in your illustration ...
This thread explains the centering clip/standoffs  https://forum.e-bodies.org/cuda-and-challenger-general-discussion-roseville-moparts/2/backglass-molding-clips/20634/msg284794#msg284794

[Mrbill426]

@Bullitt- thanks for the link

  I see 6-trim clips + 2 centering clips in your illustration ...
This thread explains the centering clip/standoffs  https://forum.e-bodies.org/cuda-and-challenger-general-discussion-roseville-moparts/2/backglass-molding-clips/20634/msg284794#msg284794